Honeywell S8610U3009 Ignition Control Module

Honeywell S8610U3009 Replacement Part

NOTE: THIS PART IS NO LONGER AVAILABLE. IT HAS BEEN REPLACED BY PART # S8610U3009/U

Includes:

• (1) - Control Board (S8610U3009)
• (1) - Spade Connector (-)
• (1) - Terminal Nut to Spade Connector (-)
• (3) - Black Wire Nut (-)
• (1) - Sticker Sheet (-)
• (1) - Status LED Sticker (-)
• (1) - Timing Select Settings Sticker (-)
• (1) - Installation Instructions (69-1955-02)

Specifications

• Gas Type: Natural or LP
• Control Voltage: 24 VAC (18-30 VAC), 50/60 Hz
• Anticipator Setting: 0.1A Plus Valve Load @ 24 VAC
• Pilot Valve MAX Amperage: 1.0 A
• Main Valve MAX Amperage: 2.0 A
• Pre-Purge Timing: 0 or 30 Seconds (Field Selectable)
• Trial for Pilot Ignition: 15 or 90 Seconds (Field Selectable)
• Ignition Sequence Type: Retry
• Flame Failure Response Time: 2 Seconds Max
• Operating Temperature: -40 to 165 Degrees Fahrenheit When Used With 2.0 A Main Valve
• Relative Humidity: 0-95% Non-Condensing
• Board Dimensions:
• Length: 5 1/4"
• Width: 4"
• Depth: 2"

Replaces Old Honeywell Part Numbers

• CNT01012
• MOD01605

Other Part Numbers

Honeywell, S8610U, 50056038-001, ANSI Z21.20, 50019481-001

Fits Models:

(Press ctrl + F to find model number below.)

Various. (Call 734-326-3900 with your model and serial number for more information.)